Colorfull Antique Wash
Colorfull Antique Wash is a dust-less way to "antique" your concrete 3 or 4 days after it has been stamped with our Liquid Stamp Release. It requires no pressure washing. Colorfull Antique Wash is a blend of cement, carefully graded silica sands, synthetic iron oxide pigments, dispersing agents, binders and other additives to assist in proper adhesion.
Colorfull Antique Wash should be used at the rate of ½# of dry material to one gallon of water. Add material to water and mix well. This material can be applied by the use of a roller, brush or a common garden watering can. Thoroughly saturate concrete and then let dry COMPLETELY. Using a nylon brush or stiff bristled broom, remove excess material until desired effect is achieved. The material removed will be negligible. A second color application, if desired, may be done at this time. Allow to dry completely and remove any excess material to desired effect. This material must be sealed or eventually will wear away.
Ten pounds of dry Antique Wash will cover approximately 500 square feet. One gallon of prepared material will cover approximately 25 square feet.
When working with this product all personnel must wear OSHA-NIOSH approved masks. Avoid inhalation and contact with skin or eyes. Prolonged use may cause serious lung damage. Do Not Take Internally. Wear rubber gloves and aprons to protect skin and safety goggles for eyes. See MSDS for further instructions. Wash hands prior to eating or smoking. Wash clothes after use of product. Keep out of reach of children. Do not take internally.
This product is intended for use only by licensed contractors, experienced and trained in the use of this material. Since no control of its selection or application is made no guarantee is expressed or implied regarding its use. Admixture's only liability shall be the replacement of any product proven to be defective.